There's not much you can do, just be sure to store them in a dry place, and be careful when you have to move them.
What's their brand anyway?
Seagate drives, as well as most low-end Western Digital models, are known to have really high failure rates, while Hitachi drives are almost indestructible, and Toshiba drives are also quite reliable.
A few useful articles (they don't really talk about external drives, but there isn't too much of a difference with internal drives anyway):
https://www.backblaze.com/blog/hard-drive-reliability-q3-2015/
https://www.backblaze.com/blog/hard-drive-reliability-q4-2015/
https://www.backblaze.com/blog/hard-drive-reliability-stats-q1-2016/
Comment has been collapsed.
Brands... well... one is a Western Digital and the other is a Lacie (Seagate). I haven't tested my 3e lacie yet (Hitachi).
Stores only keeps those two brands... so I really had no choise.
I'm starting to think... perhaps I should make a small pc and throw all those disk in so they would spin 24/7... that way I could perhaps automate a scandisk or Something like that each week.
Comment has been collapsed.
No, all consumer drives use exactly the same interface (SATA), whether they're used for RAID or not.
There're drives that use a slightly different interface (SAS), but those are used only for high-powered servers.
As for recommendations, I don't follow the hardware market closely anymore, so I can't really help in that department...
Besides, I don't even know where would you buy it.
Google is your friend!
Comment has been collapsed.
Ty. I'll check while my drive does the scandisk... still 6 hours to go.
I vaguely remember a news I read somewhere about WD adding a firmware block to their drive to prevent people using non Red drive from being usable in Raid... not sure if it applies to NAS.
Comment has been collapsed.
11 Comments - Last post 9 minutes ago by Yamaraus
4 Comments - Last post 26 minutes ago by aquatorrent
3 Comments - Last post 1 hour ago by NobodyNo
7 Comments - Last post 2 hours ago by Chris76de
941 Comments - Last post 4 hours ago by InSpec
1,170 Comments - Last post 4 hours ago by Formidolosus
293 Comments - Last post 4 hours ago by Creative1989
71 Comments - Last post 4 minutes ago by Oppenh4imer
1,981 Comments - Last post 4 minutes ago by MeguminShiro
145 Comments - Last post 10 minutes ago by Cbasplay
10,371 Comments - Last post 29 minutes ago by CTPAX001RUS
133 Comments - Last post 37 minutes ago by Alpha2749
19 Comments - Last post 41 minutes ago by CultofPersonalitea
29 Comments - Last post 44 minutes ago by Ratz0
I've got a couple of external drives I use for backup and storage. They're not plugged often I mostly plug & copy the file from / to the drive as I need. Once in a while (like each 6 months) I do a little check on them... and they kinda all fail.
I'm testing one this morning... everything looks fine in Acronis drive monitor (disk is like 8 days of power on time since purchase)... but I started a scandisk with full disk check for badblocks just to be sure and... it has a lot. It had none when I purchased it... I always do a full drive check before copying data.
What should / could I do to prevent this?
Comment has been collapsed.